Hashboard PIC file containing key data and setup parameters for Hashboard operation. If the file is abnormal or damaged, the hash board cannot operate normally. It is necessary to reprogram the file to the PIC chip.
The tools required to burn the PIC file of the hash board are:
PC, hashboard, PICkit3 or PICkit3.5 or PICkit4.
First, we need to download and install the PICkit burning tool (it is recommended to download from the official website), then connect the hash board to the computer through the PICkit Dupont cable, connect the USB port to the computer, and use the 6-pin terminal to connect the hash board data burning test points.
After the above operations are completed, open the downloaded program "MPLAB IPE" and burn the PIC file.
The specific operation steps are as follows:
1. Select the name corresponding to the device, for example: PIC16F1704;
2. Click "Power" to select the voltage setting, the setting voltage of PIC16F1704 is 3.3V;
3. Then click "Operate". Click "browse" to select the file (.HEX file) to be burned.
4. Click "Connect" to connect.
5. Click the "program" button and click "verify" when finished.
6. After completion, it will prompt that the verification is successful, which proves that the programming is completed.
The tools required to burn the PIC file of the hash board are:
PC, hashboard, PICkit3 or PICkit3.5 or PICkit4.
First, we need to download and install the PICkit burning tool (it is recommended to download from the official website), then connect the hash board to the computer through the PICkit Dupont cable, connect the USB port to the computer, and use the 6-pin terminal to connect the hash board data burning test points.
After the above operations are completed, open the downloaded program "MPLAB IPE" and burn the PIC file.
The specific operation steps are as follows:
1. Select the name corresponding to the device, for example: PIC16F1704;
2. Click "Power" to select the voltage setting, the setting voltage of PIC16F1704 is 3.3V;
3. Then click "Operate". Click "browse" to select the file (.HEX file) to be burned.
4. Click "Connect" to connect.
5. Click the "program" button and click "verify" when finished.
6. After completion, it will prompt that the verification is successful, which proves that the programming is completed.
Last edited: